This special boot-mode is a feature available only for devices equipped with Qualcomm SoCs and is controlled by the primary bootloader. MSMDownload Tool basically communicates with your phone over Qualcomm’s EDL mode ( Emergency Download Mode) to flash the stock OxygenOS firmware. However, the tool was leaked for almost every OnePlus device in the past and is now available for the OnePlus 8 and OnePlus 8 Pro as well, all thanks to some awesome members of the community. It is a low-level flashing utility that is used by OnePlus (and its parent company Oppo) to carry out flashing on their devices internally. Now, if you have found yourself in this ordeal, you can easily unbrick your OnePlus 8/8 Pro using the MSMDownload tool. Unbricking a Hard-bricked OnePlus 8/8 Pro And if you cannot boot into Fastboot/Recovery mode either, it means that you cannot install the stock firmware by flashing the Fastboot ROM or Recovery Mode to unbrick it easily. If your OnePlus 8/8 Pro ticks any of the signs listed above, then it’s probably hard-bricked.

Your phone shows the Qualcomm CrashDump Mode screen and is identified as ‘ Qualcomm HS-USB Diagnostics 900E‘ in Device Manager when connected over USB.

When connected to a Windows PC using a USB, the phone is detected as ‘ QUSB_BULK‘ or ‘ Qualcomm HS-USB QDLoader 9008‘ interface under Windows Device Manager.

That’s because the secondary bootloader is inaccessible.

Your phone shows a black screen and might just vibrate when connected to the wall charger or the computer over USB.

A simple way to check this is by holding the Volume Up and Power buttons together while the phone is switched off. Your phone doesn’t boot into Fastboot and Recovery modes even after pressing the proper button combination.

Your phone shows the ‘ Your Device is corrupt‘ message while booting and performing a factory reset doesn’t make any difference.So how do you differentiate if your phone has been soft-bricked or hard-bricked? Below are some of the signs that could help you figure this out. a soft-brick or a hard-brick), your OnePlus 8/8 Pro would stay stuck at the OnePlus boot screen and/or further get into a boot loop. Step 5: Flash OxygenOS Firmware on OnePlus 8/8 Pro using MSMDownload Tool.Step 4: Install Qualcomm USB Drivers (if required).Step 3: Boot your OnePlus 8/8 Pro into EDL Mode.Step 2: Launch MSMDownload Tool on your Computer.Step 1: Download Decrypted Stock OxygenOS Firmware.

Instructions to Unbrick the OnePlus 8/8 Pro.Unbricking a Hard-bricked OnePlus 8/8 Pro.

Msm download tool oneplus 8t